TM-9-2350-260-20-1-3

TANK, COMBAT, FULL TRACKED 105-MM GUN, M60 2350-00-678-5773 (HULL)

TECHNICAL MANUAL; ORGANIZATIONAL MAINTENANCE VOLUME 3 OF 4 CHAPTERS 10 THRU 15

TM-9-2350-260-20-1-3 - Page 745 of 783

TM 9-2350-260-20-1-3

STEERING CONTROL LINKAGE ADJUSTMENT (Sheet 11 of 13)

66. Using 9/16 inch wrench, tighten screw (AL).

67. Check threads at end of steering rod (AR) to make

sure threads are past check hole.

68. If threads are not showing, using 9/16 inch wrench,

remove screw (AS).

69. Remove steering rod end bearing (AT) from clevis

(AU).

70. Using 9/16 inch wrench, loosen jamnut (AV).

71. Using 9/16 inch wrench on steering rod end bearing

flat (AW), turn counterclockwise or clockwise until

threads are showing past check hole.

LEFT SIDE OF HULL (TO REAR OF FUEL TANK)

LEFT SIDE OF HULL

(TO REAR OF FUEL TANK)

72. Place steering rod end bearing (AT) into clevis (AU).

73. Using 9/16 inch wrench, install screw (AS).

74. Using 9/16 inch wrench, tighten jamnut (AV).

75. Using torque wrench with socket, tighten screw (AS)

to 15-20 lb-ft (20-27 N

•

m).

76. Using fingers, remove nut (AJ).

77. Position plate (AK) to linkage assembly.

78. Using 7/16 inch wrench, install screw (AG).

Go on to Sheet 12

TA146440

15-12