TM-9-2350-260-20-1-3
TANK, COMBAT, FULL TRACKED 105-MM GUN, M60 2350-00-678-5773 (HULL)
TECHNICAL MANUAL; ORGANIZATIONAL MAINTENANCE VOLUME 3 OF 4 CHAPTERS 10 THRU 15
TM-9-2350-260-20-1-3 - Page 742 of 783
TM 9-2350-260-20-1-3
STEERING CONTROL LINKAGE ADJUSTMENT (Sheet 8 of 13)
BEHIND LEFT AMMUNITION RACK
36. Attempt to insert locating pin (V).
37. If locating pin (V) can be inserted with locating pin
(P) inserted, go to step 47.
38. If locating pin (V) cannot be inserted with locating
pin (P) inserted, remove locating pin (P) and use
9/16 inch wrench to remove screws (W) and (X).
39. Using 9/16 inch wrench, loosen jamnuts (Y) and (Z).
40. Remove steering rod end bearings (AA) and (AB)
from clevis (AC).
41. Insert locating pins (P) and (V).
42. Using 9/16 inch wrench on steering rod end bearing
flat
(AD)
and
(AE),
turn
clockwise
or
counterclockwise until screws (W) and (X) will pass
freely through steering rod end bearing (AA) and
(AB) and holes in clevis (AC).
43. Insert screws (W) and (X) finger tight through rod
end bearings (AA) and (AB) and clevis (AC).
44. Remove locating pins (P) and (V).
45. Using 9/16 inch wrench, tighten jamnuts (Y) and (Z).
46. Using torque wrench with socket torque screws (W)
and (X) to 15-20 lb-ft (20-27 N
•
m).
DRIVER'S STATION
LEFT FRONT
Go on to Sheet 9
TA146437
15-9
Back to Top
