TM-9-2350-260-20-1-3

TANK, COMBAT, FULL TRACKED 105-MM GUN, M60 2350-00-678-5773 (HULL)

TECHNICAL MANUAL; ORGANIZATIONAL MAINTENANCE VOLUME 3 OF 4 CHAPTERS 10 THRU 15

TM-9-2350-260-20-1-3 - Page 739 of 783

TM 9-2350-260-20-1-3

STEERING CONTROL LINKAGE ADJUSTMENT (Sheet 5 of 13)

NOTE

When adjusting all steering rod end bearings, steering rods must go into steering

rod and sleeves past check holes.

When wire will not go through the check holes,

there are sufficient threads remaining.

9.

Using 9/16 inch wrench, loosen jamnuts (H) and (J).

10. Using 9/16 inch wrench, remove screw (E).

11. Remove steering rod end bearings from clevis.

Insert locating pin (B).

12. Using 9/16 inch wrench on steering rod end bearings f

lats (K) and (L), turn clockwise or counterclockwise until

steering rod end bearing (F) and clevis (G) holes line up and steering rod bearing (M) and clevis (N) holes line up

(one end at a time).

13. Place steering rod end bearings (F) and (M) into devises (G) and (N).

Go on to Sheet 6

TA146434

15-6