TM-9-2350-260-20-1-3

TANK, COMBAT, FULL TRACKED 105-MM GUN, M60 2350-00-678-5773 (HULL)

TECHNICAL MANUAL; ORGANIZATIONAL MAINTENANCE VOLUME 3 OF 4 CHAPTERS 10 THRU 15

TM-9-2350-260-20-1-3 - Page 743 of 783

TM 9-2350-260-20-1-3

STEERING CONTROL LINKAGE ADJUSTMENT (Sheet 9 of 13)

LEFT SIDE OF HULL (TO REAR OF FUEL TANK)

47. Remove 2A powerplant (page 5-2) or 2D powerplant

(page 5-27).

48. Insert locating pin (V).

49. Attempt to insert locating pin (AF).

50. If locating pin (AF) can be inserted, go to step 70.

51. If locating pin (AF) cannot be inserted, use 7/16 inch

wrench and remove screw (AG).

52. Using pliers, remove cotter pin (AH).

Throw cotter

pin away.

53. Using 3/4 inch wrench, remove nut (AJ).

54. Pull plate (AK) out and away from linkage assembly.

55. Install nut (AJ) finger tight.

56. Remove locating pin (V).

NOTE

If required, pull rod toward rear of

tank while performing step 57.

57. Using 9/16 inch wrench, remove screw (AL).

BEHIND LEFT AMMUNITION RACK

Go on to Sheet 10

TA146438

15-10