TM-9-2350-260-20-1-3

TANK, COMBAT, FULL TRACKED 105-MM GUN, M60 2350-00-678-5773 (HULL)

TECHNICAL MANUAL; ORGANIZATIONAL MAINTENANCE VOLUME 3 OF 4 CHAPTERS 10 THRU 15

TM-9-2350-260-20-1-3 - Page 741 of 783

TM 9-2350-260-20-1-3

STEERING CONTROL LINKAGE ADJUSTMENT (Sheet 7 of 13)

26. Using 9/16 inch wrench, remove screw (Q).

27. Using 9/16 inch wrench, loosen jamnut (R).

28. Remove steering rod end bearing (S) from clevis (T).

29. Insert locating pin (P).

30. Using 9/16 inch wrench on steering rod end bearing

flat (U), turn clockwise or counterclockwise until

steering control is centered when screw (Q) is

installed through rod end bearing (S) and clevis (T).

31. Install screw (Q) finger tight through rod end bearing

(S) and clevis (T).

32. Using 9/16 inch wrench, tighten jamnut (R).

33. Remove locating pin (P).

34. Using torque wrench with socket, tighten screw (Q)

to 15-20 lb-ft (20-27 N

•

m).

35. Insert locating pin (P)

DRIVER'S STATION

Go on to Sheet 8

TA146436

15-8