TM-9-2350-261-10

CARRIER, M113A2, M577A2, M1064, M1068, M1059 AND M901A1

OPERATOR'S MANUAL

TM-9-2350-261-10

  TM-9-2350-261-10 - Page 632 of 761

TM 9-2350-261-10
SERVICE BILGE PUMPS — Continued
0086 00
2.
Remove six screws, washers, and rear floor plate from floor supports. Use 1/2 inch drive socket wrench handle and 3/4
inch socket.
3.
Service rear bilge pump. Use flashlight.
4.
Remove mud and debris from bilge pump and screen. If bilge pump needs additional cleaning, notify unit maintenance.
5.
Clean vent hole. Use a wire and run it back and forth in vent hole a few times.
6.
Install rear floor plate on floor supports and secure with six washers and screws. Use 1/2 inch drive socket wrench
handle and 3/4 inch socket.
7.
Raise ramp (WP 0015 00).
0086 00-4


Back to Top