TM-9-2350-261-20-2

CARRIER, M113A2, M577A2, M1064, M1068, M1059 AND M901A1

TECHNICAL MANUAL; UNIT MAINTENANCE MANUAL - VOLUME 2 OF 4

TM-9-2350-261-20-2 - Page 880 of 1008

TM 9-2350-261-20-2

REPLACE RANGE SELECTOR LINKAGE — Continued

0407 00

ADJUSTMENT

1.

Loosen locknut (1) on range selector link (2) at transmission cross-shaft (3) end.

2.

Remove screw (4) and locknut (5) that secure range selector link (2) to cross-shaft (3).

3.

Place range selector (6) in neutral position.

4.

Pull transmission shift arm (WP 0404 00) to end of travel, then back one detent to place transmission in neutral.

5.

Adjust range selector link bearing end (7) to free pin fit at transmission cross-shaft (3).

6.

Check all range selector positions. Readjust range selector link bearing end (7), if needed, to obtain positive transmission

detents in all positions.

7.

Install range selector link (2) on transmission cross-shaft (3). Secure with screw (4) and new locknut (5).

8.

Tighten locknut (1) on range selector link bearing end (7).

0407 00-4