TM-9-2350-261-20-3

CARRIER, M113A2, M577A2, M1064, M1068, M1059 AND M901A1

TECHNICAL MANUAL; UNIT MAINTENANCE MANUAL - VOLUME 3 OF 4

TM-9-2350-261-20-3 - Page 257 of 932

TM 9-2350-261-20-3

REPLACE/REPAIR DRIVER’S SEAT POST ASSEMBLY — Continued

0483 00

11. Install two screws (17) into inboard holes and install plate (18) on post (19) with two screws (17), washers (20), and new

locknuts (21). Tighten locknuts two turns only at this time.

12. Place spacers (22) between post (19) and plate (18) at the outboard holes. Install two screws (17) through spacers and

plate. Secure with two washers (20) and new locknuts (21).

CAUTION

Take care not to tighten the locknuts too tight or the plate will bend.

13. Tighten two locknuts (21), installed in Step 11, just enough to bottom against plate (18).

14. Lower seat support (13) all the way down. Place stiffener (23) in post (19) and install cap (24). Secure with two screws

(25) and new locknuts (26).

048300-7