TM-9-2350-261-34

CARRIER, M113A2, M577A2, M1064, M1068, M1059 AND M901A1

TECHNICAL MANUAL; DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE MANUAL

TM-9-2350-261-34 - Page 298 of 785

TM 9-2350-261-34

REPAIR MULTIPIN CONNECTORS — Continued

0034 00

5.

Remove grommet (4) and retaining nut (1) from cable (3).

INSTALL CABLE CONNECTOR

NOTE

If replacing lead, cut new wire from bulk supply. Measure original length, gauge, and type

of wire.

1.

Strip insulation from leads of cable (3) to uncover just enough wire to fill well in contact (5).

2.

Slide retaining nut (1) and coupling nut (6) on cable (3).

NOTE

Make sure leads pass through proper lettered hole in grommet.

3.

Push leads of cable (3) through grommet (4) and insert in new contacts (5).

4.

Solder leads in contacts (5) and press contacts into grommet (4). Check leads for resistance.

5.

Align and install grommet (4) in plug (2). Secure with retaining nut (1).

END OF TASK

0034 00-3/4 blank