TM-9-2350-261-34

CARRIER, M113A2, M577A2, M1064, M1068, M1059 AND M901A1

TECHNICAL MANUAL; DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE MANUAL

TM-9-2350-261-34 - Page 289 of 785

TM 9-2350-261-34

REPLACE CHASSIS TURRET WIRING HARNESS (M901A1 ONLY) — Continued

0033 00

NOTE

Make sure to secure all wiring harness clamps loosened during removal procedure.

8.

Position guards (1) and (2) over rear section of wiring harness (3) near fuel tank. Secure guards with two screws (4),

washers (5), and new locknuts (6).

9.

Take proper amount of slack out of wiring harness (3) and secure to guard (2) with three clamps (7), screws (8), and

new locknuts (9).

10. Attach guard (2) to fuel tank and weldnuts with two screws (10) and new lockwashers (11).

11. Attach wiring harness (3) to front of fuel tank and left bulkhead using seven clips (12).

12. Attach wiring harness (3) to bulkhead using two clamps (13), washers (14), new lockwashers (15), and screws (16).

13. Secure wiring harness (3) to overhead with eleven clamps (17), screws (18), new lockwashers (19), and washers (20).

0033 00-8