TM-9-2350-261-34

CARRIER, M113A2, M577A2, M1064, M1068, M1059 AND M901A1

TECHNICAL MANUAL; DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE MANUAL

TM-9-2350-261-34 - Page 286 of 785

TM 9-2350-261-34

REPLACE CHASSIS TURRET WIRING HARNESS (M901A1 ONLY) — Continued

0033 00

20. Remove four screws (1), lockwashers (2), washers (3), and cable guard (4) securing connector W8 J1 (5) to floor near

bulkhead. Disconnect connector W8 J1 (5) from turret slip ring wiring harness. Discard lockwashers.

21. Cut safety wire securing connector W8 J1 (5) to screw (6). Remove screw (6), three screws (7), four lockwashers (8),

eight washers (9), four nuts (10), and connector W8 J1 (5) from bracket (11). Discard lockwashers.

22. Remove two screws (12), lockwashers (13), washers (14), clamps (15), and wiring harness (16) from left bulkhead.

Discard lockwashers.

23. Remove screw (17), lockwasher (18), washer (19), and clamp (20) securing smoke grenade arming/firing unit lead W8

P1 (21) to rear engine compartment bulkhead. Discard lockwasher.

24. Disconnect wiring harness lead W8 P1 (21) from smoke grenade arming/firing unit connector (22).

003300-5