TM-9-2350-261-34

CARRIER, M113A2, M577A2, M1064, M1068, M1059 AND M901A1

TECHNICAL MANUAL; DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE MANUAL

TM-9-2350-261-34 - Page 364 of 785

REPAIR/REPLACE ACCELERATOR STOP SUPPORT ASSEMBLY — Continued

ASSEMBLY

NOTE

To install nut (2) only, go directly to Step 4.

1.

Position support assembly (1) on front bulkhead 4-11/16 inches (11.9 cm) from left edge of support to engine

compartment bulkhead. Use straight edge to locate and scribe a line between mounting holes.

WARNING

Unsafe welding practices can cause serious injury from fire, explosions, or harmful agents.

Allow only authorized personnel to weld or cut metals, and follow safety precautions in TC

9-237. Protective clothing and goggles must be worn; adequate protective equipment used, a

suitable fire extinguisher kept nearby; and requirements of TC 9-237 strictly followed.

2.

Weld support assembly (1) to floor plate, using dimensions shown, in accordance with TC 9-237. Use electrode type

5356.

3.

Prepare and paint surface in accordance with TM 43-0139.

4.

Position nut (2) on support (1). Secure with two rivets (3).

5.

Install nut (4) and screw (5) into nut (2).

005200-3

0052 00

TM 9-2350-261-34