TM 9-2350-261-34
INSTALL ENGINE COOLANT HEATER KIT (M113A2, M901A1, AND
M1059 ONLY) — Continued
0059 00
57. Remove four screws (13), clamps (14), and personnel heater fuel hose (15) from four weldnuts (16).
58. Install personnel heater fuel hose (15) and coolant heater fuel hose (1) on four weldnuts (16). Secure with four clamps
(14), one clamp (17), and four screws (13).
59. Secure coolant heater fuel hose (1) to adapter body (18) with sleeve (19) and nut (20).
60. Remove batteries and retainers from battery box (see your -20). Clean battery box and battery box cover. See TM
9-6140-200-14.
61. Clean battery box with solvent, cleaning compound.
62. Renew adhesive backing on insulation sheets with solvent, cleaning compound. Wait 10 to 20 seconds until adhesive
becomes tacky.
63. Install insulation sheets (1), (2), (3), (4), and (5) and strip (6) in battery box (7).
64. Install insulation sheet (8) on battery box cover (9).
65. Install two clamps (10) on heat exchanger (11).
66. Install two grommets (12) and heat exchanger (11) in battery box (7).
67. Remove two blank grommets from power plant compartment. Discard grommets.
68. Install two grommets (13) in power plant compartment bulkhead.
0059 00-14