TM-9-2350-261-34

CARRIER, M113A2, M577A2, M1064, M1068, M1059 AND M901A1

TECHNICAL MANUAL; DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE MANUAL

TM-9-2350-261-34 - Page 459 of 785

TM 9-2350-261-34

INSTALL ENGINE COOLANT HEATER KIT (M113A2, M901A1, AND

M1059 ONLY) — Continued

0059 00

108. Install wiring harness (1) on two weldnuts (2). Secure with two clamps (3) and screws (4).

109. Remove three screws (5) and clamps (6) that secure fuel control cable (7) to three weldnuts (8).

110. Install wiring harness (1) and fuel control cable (7) on three weldnuts (8). Secure with three screws (5), clamps (6), and

clamps (9).

111. Lower power plant grille assembly (see your -20).

112. Remove four screws (10), washers (11), and plate from grille. Discard plate.

113. Install upper tube (12) on exhaust pipe (13). Secure with clamp (14). Do not tighten.

114. Position upper tube (12) and gasket (15) on grille.

115. Secure upper tube (12) to grille with four screws (10) and washers (11).

0059 00-26