TM-9-2350-261-34
CARRIER, M113A2, M577A2, M1064, M1068, M1059 AND M901A1
TECHNICAL MANUAL; DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE MANUAL
TM-9-2350-261-34 - Page 461 of 785
TM 9-2350-261-34
INSTALL ENGINE COOLANT HEATER KIT (M113A2, M901A1, AND
M1059 ONLY) — Continued
0059 00
119. Replace standard generator belts with kit belts (see your -20).
120. Replace standard fan drive belts with kit belts (see your -20).
121. Open fuel tank shutoff valve (6).
FOLLOW-THROUGH STEPS
1.
Install personnel heater (see your -20).
2.
Fill carrier cooling system (see your -20).
3.
Connect battery ground lead (see your -20).
4.
Bleed coolant heater fuel line (see your -20).
5.
Start coolant heater (see your -10). Check that heater operates properly and does not leak. Turn coolant heater off.
6.
Install rear and right front floor plates (see your -20).
7.
Install driver’s power plant access panel (see your -20).
8.
Install power plant rear access panel (see your -20).
9.
Close power plant front access panel (see your -20).
10. Raise trim vane (see your -10).
11. Raise and lock ramp (see your -10).
12. Stop/shutdown engine (see your -10).
END OF TASK
0059 00-28
Back to Top
