TM-9-2350-261-34

CARRIER, M113A2, M577A2, M1064, M1068, M1059 AND M901A1

TECHNICAL MANUAL; DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE MANUAL

TM-9-2350-261-34 - Page 471 of 785

TM 9-2350-261-34

INSTALL ENGINE COOLANT HEATER KIT (M577A2 AND M1068 ONLY) — Continued

0060 00

48. Install hose (14) on elbow (16). Secure with clamp (17).

49. Clean external pipe threads of elbow (19) and drain cock (20) with solvent, cleaning compound.

WARNING

Adhesive, primer, sealant compounds, and isopropyl alcohol are toxic and flammable. These

compounds are toxic to eyes, skin, and respiratory tract. Continued exposure can make you

dizzy and irritate your eyes and throat.

Always use in well ventilated areas, away from heat, sparks, and flames. Do not breathe fumes.

Do not allow into contact with skin and eyes. Use goggles or face shield and protective gloves.

50. Apply a thin, even coat of primer and then sealing compound (WP 0105 00, Item 17) to cleaned external pipe threads of

elbow (19) and drain cock (20). Do not apply primer or sealing compound beyond small end of threads.

51. Remove two screws (15), washers (16), plate (17), and gasket (18) from engine right side. Discard plate and gasket.

Retain screws and washers.

52. Install elbow (19) and drain cock (20) in mount (21).

53. Apply a thin coat of sealing compound (WP 0105 00, Item 18) to both sides of gasket (22) before assembly.

54. Install mount (21) and gasket (22) over engine right side opening. Secure with two screws (15) and washers (16).

0060 00-10