TM-9-2350-277-20-1
CARRIER M113A3, M577A3, M1059A3, M1064A3, M1068A3 AND M58
TECHNICAL MANUAL; UNIT MAINTENANCE MANUAL VOLUME 1 OF 6
TM-9-2350-277-20-1 - Page 648 of 855
TM 9-2350-277-20-1
MSD/ICE TEST 80 BATTERY CURRENT
0132 00
THIS WORK PACKAGE COVERS:
Test (page 0132 00-1).
INITIAL SETUP:
Maintenance Level
Unit
Tools and Special Tools
Electrical connector pliers (WP 0926 00, Item 31)
Personnel Required
Unit Mech 63T10
References
TM 9-2350-277-10
Equipment Condition
Engine stopped (TM 9-2350-277-10)
Vehicle blocked (TM 9-2350-277-10)
All electrical accessories turned off (TM 9-2350-277-10)
MSD/ICEhookeduptoDCA6(WP011700)
TEST
1.
Select
ICE Testing
from programs menu.
2.
Select button
1. Serial ICE
3.
Select button
1. ICE Tests
NOTE
All M113A3 variants are covered under
M113A3-M1068A3 APC
vehicle selection
4.
Select
M113A3-M1068A3 APC
, then select the
OK
button.
NOTE
Once MSD/ICE hook up screen
OK
button is selected, the MSD/ICE will perform a self test.
If self test fails, notify supervisor.
5.
Select
OK
button on the MSD/ICE hook up screen to proceed.
6.
Select
OK
button after successful self test.
7.
Follow on screen preparation for DCA offsets tests. Select
OK
button.
8.
Use Tab and Shift-Tab to move from one list box to another.
9.
Use spacebar to select/deselect the test.
10. Select
71/80 Start/Battery Current
from
STARTING SYSTEM
list box. Select
Run Test(s)
button.
11. Turn MASTER SWITCH to ON. See TM 9-2350-277-10.
12. Depress START button for five seconds.
a.
If MSD reads
0.0
or less, test passes.
b.
If error message appears, see TM 9-6625-2301-14&P.
c.
If engine cranks normally, but reading is erratic or cannot be obtained, go to MSD/ICE DCA current shunt
diagnostic troubleshooting (WP 0142 00).
13. Turn MASTER SWITCH to OFF. See TM 9-2350-277-10.
14. Return to troubleshooting.
0132 00-1/2 blank
Change 5
Back to Top
