TM-9-2350-277-20-3

CARRIER M113A3, M577A3, M1059A3, M1064A3, M1068A3 AND M58

TECHNICAL MANUAL; UNIT MAINTENANCE MANUAL VOLUME 3 OF 6

TM-9-2350-277-20-3 - Page 599 of 941

REPLACE REAR MAIN WIRING HARNESS (M1068A3 ONLY) — Continued

77. Connect circuit 37A lead (1) to right utility outlet lead (2).

78. If NBC unit is installed, connect circuit 415 lead (3) to NBC unit switch.

79. Connect circuit 23 lead (4) and circuit 24 lead (5) to right taillight (6).

80. Install four clamps (7) on circuit 29 lead (8). Secure ground lead (9) and clamps on three weldnuts (10) with two new

lockwashers (11), three screws (12), and flat washers (13).

81. Install ground lead (9) on right fuel quantity sending unit (14). Secure with screw (15), new lockwasher (16), and

new lockwire (17).

82. Connect circuit 29 lead (8) on right fuel quantity sending unit (14).

FOLLOW-THROUGH STEPS

END OF TASK

0365 00-2

8

Change 4

0365 00

TM 9-2350-277-20-3

1.

Install rear floor plate (WP 0544 00).

2.

Connect battery ground lead (WP 0338 00).

3.

Install battery access cover (see your -10).

4.

Turn MASTER SWITCH to ON (see your -10). Check that electrical system works properly.

5.

Start engine (see your -10).

6.

Raise and lock ramp (see your -10).

7.

Stop engine (see your -10).