TM-9-2350-277-20-6

CARRIER M113A3, M577A3, M1059A3, M1064A3, M1068A3 AND M58

TECHNICAL MANUAL; UNIT MAINTENANCE MANUAL VOLUME 6 OF 6

TM-9-2350-277-20-6 - Page 250 of 487

TM 9-2350-277-20-6

REPLACE DVE SENSOR SET ASSEMBLY POWER CABLE

0866 01

THIS WORK PACKAGE COVERS:

Removal (page 0866 01-1).

Test and Inspection (page 0866 01-1).

Installation (page 0866 01-2).

INITIAL SETUP:

Maintenance Level

Unit

Tools and Special Tools

General Mechanic’s Tool Kit (WP 0926 00, Item 65)

Personnel Required

Unit Mechanic

Equipment Condition

Engine stopped (TM 9-2350-277-10)

DVE switch off (TM 9-2350-277-10)

Sensor set assembly removed (TM 9-2350-277-10)

REMOVAL

1.

Remove two screws (1) securing power cable (2) to sensor set assembly (3).

2.

Carefully remove power cable (2) connector P1 from jack on sensor set assembly(3).

TEST AND INSPECTION

1.

Check pin to pin continuity of power cable. If power cable fails continuity test or is damaged, discard power cable.

086601-1

Change 5