TM-9-2350-277-34

CARRIER M113A3, M577A3, M1059A3, M1064A3, M1068A3 AND M58

TECHNICAL MANUAL; DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE MANUAL

TM-9-2350-277-34 - Page 157 of 871

TM 9-2350-277-34

REPLACE ENGINE — Continued

0015 00

NOTE

There are two sets of index splines located on the engine flywheel and transmission drive

coupling, 180 degrees apart.

Transmission drive coupling may be rotated with a screw driver to align index splines for

assembly. Do not use fingers.

5.

Rotate transmission drive coupling (10) to align with engine flywheel indexing spline (11).

6.

Using engine and transmission stand, adjust transmission to align with engine. With proper alignment, mate engine to

transmission.

NOTE

Do not torque engine to transmission attaching screws and nuts until all twelve screws have

been seated.

7.

Install washer (1) and new locknut (2). TORQUELOCKNUTTO25-27LB-FT(34-37N·m)

.

8.

Install screw (3), two washers (4), and new locknut (5). TORQUE LOCKNUT TO 25-27 LB-FT (34-37 N·m).

0015 00-24

Change 2