TM-9-2350-277-34

CARRIER M113A3, M577A3, M1059A3, M1064A3, M1068A3 AND M58

TECHNICAL MANUAL; DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE MANUAL

TM-9-2350-277-34 - Page 371 of 871

TM 9-2350-277-34

REPAIR COMMANDER’S CUPOLA (M113A3, M1059A3, M1064A3, AND

M58 ONLY) — Continued

0051 00

WARNING

Adhesive, primer, sealant compounds, and isopropyl alcohol are toxic and flammable. These

compounds are toxic to eyes, skin, and respiratory tract. Continued exposure can make you

dizzy and irritate your eyes and throat.

Always use in well ventilated areas, away from heat, sparks, and flames. Do not breathe fumes.

Do not allow into contact with skin and eyes. Use goggles or face shield and protective gloves.

NOTE

Surface on seal marked BOND THIS SIDE should be glued to hull.

10. Apply adhesive to cleaned mating surface around vision block opening. Allow adhesive to become tacky. Install seal

(25) on hull.

11. Install arm (22) and washer (24) in hull bracket. Secure with new spring pin (23).

12. Install thumbscrew (21) in arm (22). Deform first thread of thumbscrew to prevent easy removal.

NOTE

Do not drill deeper than length of drive screw.

13. Drill three new 3/32 inch holes close to old drive screw holes. Use new clip (19) for template.

0051 00-14

Change 2