TM 9-2350-277-34
REPAIR FAN AND GENERATOR VARIABLE SPEED DRIVE (OLD
CONFIGURATION) — Continued
0115 00
9.
Remove cover plate (2) and preformed packing (5) from rear housing (4). Discard preformed packing. Remove two
jacking screws (6) from cover plate.
10. Press encased oil seal (1) out of cover plate (2). Discard oil seal.
11. Remove six screws (1) and washers (2) from front housing (3).
NOTE
When the front housing is separated from the rear housing, the inner housing with shaft and
clutch assembly may stay with the front housing.
12. Separate front housing (3) from rear housing (4). Tap off at shaft with rubber hammer.
13. Remove gasket (5) from rear housing (4). Discard gasket.
14. Remove the large lock ring (6) that secures the clutch housing assembly (7) to the front housing (3).
0115 00-4
Change 2