TM-9-2350-311-34-1

HULL, POWERPLANT, DRIVE CONTROLS, TRACKS, SUSPENSION, AND ASSOCIATED COMPONENTS: HOWITZER, MEDIUM, SELF-PROPELLED, 155MM

TECHNICAL MANUAL; DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE MANUAL

SEPTEMBER 1994

TM-9-2350-311-34-1 - Page 103 of 352

WARNING

b. Installation

TM 9-2350-311-34-1

●

Dry-cleaning solvent (P-D-680) is toxic and flammable. Wear protective goggles

and gloves and use only in a well-ventilated area. Avoid contact with skin, eyes,

and clothes. Do not breath vapors. Do not use near open flame or excessive heat.

The flashpoint for type #1 is 100°F (38°C), and for type #2 is 138°F (59°C). If you

become dizzy while using dry-cleaning solvent, get fresh air immediately and

obtain medical aid. If contact with eyes is made, wash your eyes with water and

obtain medical aid immediately.

• CARC paint contains isocyanate, a constituent that can cause respiratory effects

during and after the application of the material. CARC paint may produce itching

and reddening of the skin, a burning sensation of the throat and nose, and watering

of the eyes. Refer to TM 9-2350-311-20-1 for complete handling instructions.

●

Adhesives are toxic and flammable. Apply adhesives only in a well-ventilated area.

Avoid contact with skin, eyes, and clothes, and don’t breath vapors. Do not use

near heat, sparks, or open flame. Read and follow all warnings and instructions on

labels of adhesives. If contact with skin or eyes is made, wash area with water and

seek medical aid immediately.

1 Clean pad mounting surfaces thoroughly with dry-cleaning solvent and remove all old pad and adhesive

residue.

2 Using paint remover or sand paper, remove all paint from mounting surface.

3 Apply adhesive and install new pads (1 thru 4) as required.

NOTE

FOLLOW-ON MAINTENANCE:

Install fuel tanks (para 5-2)

5-21