TM-9-2350-311-34-1

HULL, POWERPLANT, DRIVE CONTROLS, TRACKS, SUSPENSION, AND ASSOCIATED COMPONENTS: HOWITZER, MEDIUM, SELF-PROPELLED, 155MM

TECHNICAL MANUAL; DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE MANUAL

SEPTEMBER 1994

TM-9-2350-311-34-1 - Page 106 of 352

TM 9-2350-311-34-1

5-4 FUEL TANK RETAINING STRAPS AND CHANNEL GROUP — CONTINUED

c. Assembly

1 Install new pad (18), as required (para 5-3).

2 Connect turnbuckle (15) to side retaining strap (17) and top retaining strap (16).

3 Install new pad (19), as required (para 5-3).

4 Assemble new spring pin (20), stud (12), and nut (13) to channel (11).

d. Installation

1 Install flat washer (14), nut (13), stud (12), and channel (11) through hull recess in engine compartment.

NOTE

Nut and retainer are located inside hull crew compartment at forward bulkhead of

CLGP stowage area.

2 Install retainer (10) and nut (9).

3 Install bracket (8) and two screws (7).

4 Install rear retaining strap assembly (6).

5 Install three flat washers (5), three nuts (4), and three screws (3).

6 Install headed pin (2).

7 Install new cotter pin (1).

5-24