TM-9-2350-311-34-1

HULL, POWERPLANT, DRIVE CONTROLS, TRACKS, SUSPENSION, AND ASSOCIATED COMPONENTS: HOWITZER, MEDIUM, SELF-PROPELLED, 155MM

TECHNICAL MANUAL; DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE MANUAL

SEPTEMBER 1994

TM-9-2350-311-34-1 - Page 233 of 352

TM 9-2350-311-34-1

1 Assemble electrical leads as required (TM 9-2350-311-20-1).

NOTE

Refer to electrical wiring diagram for installation of leads.

2 Solder lead (56) to capacitor board (59) (TB SIG 222).

3 Solder three leads (57) to capacitor board (55) (TB SIG 222).

Acetone solvent is toxic and flammable. Use only in well-ventilated area. Do not

breathe vapors. Do not use near open flame or excesive heat. Failure to heed warning

could cause serious injury or even death.

NOTE

Step 4 applies only if capacitor boards (55 and 59) are used.

4 Clean two capacitor boards (55 and 59) with acetone solvent to remove remains of pressure-sensitive tape.

5 Install two strips of pressure-sensitive tape to each capacitor board (55 and 59). Do not remove protective

coating.

6 Clean housing (56) mounting surface with acetone solvent.

7 Remove protective coating on tape and install two capacitor boards (55 and 59) as shown below.

7-97