TM-9-2350-311-34-2

CAB, ARMAMENT, SIGHTING AND FIRE CONTROL, ELEVATING AND TRAVERSING SYSTEMS AND ASSOCIATED COMPONENTS HOWITZER, MEDIUM, SELF-PROPELLED, 155MM

TECHNICAL MANUAL; DIRECT AND GENERAL SUPPORT MAINTENANCE MANUAL

SEPTEMBER 1994

  TM-9-2350-311-34-2 - Page 368 of 552

TM 9--2350--311--34--2
7--8
Change 3
7--1
RAMMER ASSEMBLY — CONTINUED
b. Disassembly — Continued
17
Remove two cap screws (57), four cap screws (58), and tray support (59) from flange of rammer support
(60).
18
Remove five machine screws (61), five flat washers (62), and cover assembly (63) from rammer support
(60).
19
Remove and discard spring pin (64).
20
Remove cotter pin (65), flat washer (66), headed straight pin (67), and actuating lock lever (68). Discard
cotter pin.
21
Remove headless shoulder pin (69), dial pointer (70), helical compression spring (71), flat washer (72), and
rammer switch actuator (73).
22
Remove seven machine screws (74), seven lockwashers (75), access cover (76), and cover gasket (77)
from rammer support (60). Discard lockwashers and gasket cover.
23
Remove cap screw (78).
24
Remove two lubrication fittings (79).
25
Remove lockwire (80), four cap screws (81), four spring tension washers (82), and cover assembly (83) from
rear of rammer support (60). Discard lockwire.
26
Remove shoulder screw (84), nonmetallic bushing (85), and flat washer (86).
27
Remove straight shaft (87) from rammer support (60).


Back to Top