TM-9-2520-234-35
POWER TRAIN ASSEMBLY; ALLISON MODEL XTG411-2A
TECHNICAL MANUAL; FIELD AND DEPOT MAINTENANCE MANUAL
JULY 1962
TM-9-2520-234-35 - Page 138 of 323
*C2
CHAP
5,
SEC
IV .
TORQUE CONVERTER REBUIL D
PAR
8 3
b . Torqu e Converte r Pum p
(1) Straighten the tabs of lock strips on
the converter pump hub (fig. 145).
(2) Using a 7/16-inch wrench, remove
eight self-locking bolts and four lock strips
retaining the torque converter pump hub in the
converter pump. Remove the hub.
(3) Remove two hook-type seal rings 87
(fig. 373, fold-out 2) from pump nub 88.
(4) Remove retaining ring 92 retaining
bearing 91 in converter pump hub 88. Press
the bearing from the hub.
c. Torque Converter Turbine
(1) Do not remove the ball bearing from
the turbine assembly, unless replacement is
necessary (fig. 146).
Figure 145. Straightening corners of converter pump
hub lock strip
(2) If necessary to remove the bearing,
pry it from the turbine hub.
d . Torque Converter Stator
(1) Rotating the stator freewheel race
in a clockwise direction, remove it from the
stator assembly (fig. 147).
Figure 146. Torque converter turbine assembly
Figure 147. Removing stator freewheel race and
thrust bearing assembly from stator
10 6
Back to Top
