TM-9-2520-238-34

M113A1 FOV, M113A2 FOV, M548 AND M548A1

TECHNICAL MANUAL; DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE MANUAL; RIGHT ANGLE DRIVE, COOLING FAN; GEARCASE, TRANSFER; DRIVE ASSEMBLY, FINAL; DIFFERENTIAL, STEERING CONTROL; BRAKE, SINGLE DISK; CYLINDER ASSEMBLY, HYDRAULIC BRAKE

TM-9-2520-238-34

  TM-9-2520-238-34 - Page 146 of 319

TM 9-2520-238-34
REPAIR TRANSFER GEARCASE F — Continued
0019 00
NOTE
Do not remove tapered roller bearing cones or cups that are pressed in plates unless inspection
indicates a replacement is needed.
25. Remove output gear (1) from gearcase housing (2). Separate bearing cone (3) and bearing cone (4) from gear.
26. Remove helical gearshaft cluster (5) as an assembly from housing (2). Separate bearing cone (6) and bearing cone(7)
from cluster. If replacement is needed, use brass drift pin and hammer to remove spring pin (8). Separate second
intermediate gear (9) from primary pump-drive gear (10). Discard spring pin.
27. Remove first intermediate gear (11) from housing (2). Separate bearing cone (12) and bearing cone (13) from gear.
0019 00-10


Back to Top