TM-9-2520-272-34P
CROSS DRIVE TRANSMISSION WITH CONTAINER MODEL X200-4 & 4A
TECHNICAL MANUAL; INTERMEDIATE, DIRECT, AND GENERAL SUPPORT MAINTENANCE MANUAL (INCLUDING REPAIR PARTS AND SPECIAL TOOLS LIST)
TM-9-2520-272-34P - Page 2 of 488
TM 9-2520-272-34&P
LIST OF WARNINGS
To troubleshoot transmission, stop engine before installing or removing pressure gages from transmission.
Use extreme care when making pressure checks on transmission with vehicle in motion.
Watch for pivot steer.
Perform tests outdoors or in a well-ventilated area to avoid illness or death caused by inhalation of carbon monoxide from
the engine exhaust.
Dry cleaning solvent P-D-680 is toxic and flammable.
To avoid injury, wear protective goggles and gloves and use in a
well-ventilated area.
Avoid contact with skin, eyes, and clothes, and do not breathe vapors.
Do not use near open fire or
excessive heat.
The flash point for Type I dry cleaning solvent is 100°F (380C), and for Type II is 138°F (500C).
If you
become dizzy while using dry cleaning solvent, get fresh air immediately and get medical aid.
If contact with eyes is made,
wash your eyes with water and get medical aid immediately.
Compressed air used for testing or cleaning purposes must not exceed 30 pounds of pressure per square inch.
Use only
with effective chip guards and protective personal equipment including goggles or face shield and gloves.
Never blow
compressed air toward another person.
Hot equipment, hot parts, and steam can burn you.
To avoid injury, use with effective personal protective equipment
(goggles, face shield gloves, etc.).
Always wear leather gloves when working with steam equipment to protect you from
parts that are or might be hot.
Never point a steam hose toward another person.
Shipping container will normally have up to one psi internal differential pressure, but high ambient temperature and check
valve malfunction may cause increased pressure within the container.
Opening a pressurized container :
nay cause bodily
injury.
To avoid injury, be sure internal and external pressures have been equalized.
Check slings and lifting devices for cuts, breaks, or wear before hoisting transmission and during hoisting.
Slings and
lifting devices can break and cause injury or death.
Transmission weighs about 975 pounds (442 kg).
Transmission and container weigh about 1565 pounds (710 kg).
To
avoid injury or death, keep out from under and clear of transmission at all times.
Do not let transmission swing freely
during hoisting.
Adapter plate weighs 127 pounds (58 kg).
Lift plate with hoist to avoid injury.
Change 1
PIN: 062156-002
Back to Top
