TM-9-2520-272-34P
CROSS DRIVE TRANSMISSION WITH CONTAINER MODEL X200-4 & 4A
TECHNICAL MANUAL; INTERMEDIATE, DIRECT, AND GENERAL SUPPORT MAINTENANCE MANUAL (INCLUDING REPAIR PARTS AND SPECIAL TOOLS LIST)
TM-9-2520-272-34P - Page 7 of 488
WARNING
Dry cleaning solvent P-D-680 is toxic and flammable.
To avoid injury, wear protective goggles and gloves
and use in a well-ventilated area.
Avoid contact with skin, eyes, and clothes, and do not breathe vapors.
Do not use near open fire or excessive heat.
The flash point for Type I dry cleaning solvent is 100°F
(38°C), and for Type II is 138°F (50°C).
If you become dizzy while using dry cleaning solvent, get fresh air
immediately and get medical aid.
If contact with eyes is made, wash your eyes with water and get medical
aid immediately.
Compressed air used for testing or cleaning purposes must not exceed 30 pounds of pressure per square
inch.
Use only with effective chip guards and protective personal equipment including goggles or face
shield and gloves.
Never blow compressed air toward another person.
Hot equipment, hot parts, and steam can burn you.
To avoid injury, use with effective personal protective
equipment (goggles, face shield gloves, etc.).
Always wear leather gloves when working with steam
equipment to protect you from parts that are or might be hot.
Never point a steam hose toward another
person.
Shipping container will normally have up to one psi internal differential pressure, but high ambient
temperature and check valve malfunction may cause increased pressure within the container.
Opening a
pressurized container may cause bodily injury.
To avoid injury, be sure internal and external pressures
have been equalized.
Check slings and lifting devices for cuts, breaks, or wear before hoisting transmission and during hoisting.
Slings and lifting devices can break and cause injury or death.
A X2004 and X200-4A Transmission weighs about 975 pounds (442 kg).
Transmission and container weigh about 1565 pounds (710 kg).
To avoid injury or death, keep out from
under and clear of transmission at all times.
Do not let transmission swing freely during hoisting.
Adapter plate weighs 127 pounds (58 kg).
Lift plate with hoist to avoid injury.
WARNING
When rotating transmission vertical to horizontal position, weight of transmission is transferred from one
sling to the other.
When the center of gravity shifts, transmission may suddenly tilt, thrusting heavy
momentary stress on sling and hoist.
To avoid injury or death, keep out from under and clear of
transmission at all times.
Spring-loaded parts can fly and injure you.
Always follow specified instructions when removing bolts from
covers that are attached to valve assemblies.
Change 2
a
Back to Top
