TM-9-2520-272-40

CROSS-DRIVE TRANSMISSION WITH CONTAINER MODEL X200-4A

TECHNICAL MANUAL; SUSTAINMENT MAINTENANCE MANUAL

FEBRUARY 2012

TM-9-2520-272-40 - Page 514 of 620

TM 9-2520-272-40

0063

CHECK OUTPUT SHAFT DRAG, LEFT AND RIGHT SIDE

1. Straighten bent tab of washer (Figure 1, Item 1) that retains bolt (Figure 1, Item 3) on output f ange (Figure

1, Item 1), if necessary.

2. Turn output f ange (Figure 1, Item 1) to right (clockwise) using torque wrench on bolt (Figure 1, Item 3). Torque

while turning should not exceed 20 lb-ft (27 N·m).

3. Punch dimple in washer (Figure 1, Item 4) if dimple is not present. Dimple must go down into dimple hole

(Figure 1, Item 2) in left and right output f anges (Figure 1, Item 1).