TM-9-2520-272-40

CROSS-DRIVE TRANSMISSION WITH CONTAINER MODEL X200-4A

TECHNICAL MANUAL; SUSTAINMENT MAINTENANCE MANUAL

FEBRUARY 2012

TM-9-2520-272-40 - Page 507 of 620

TM 9-2520-272-40

0061

SUSTAINMENT MAINTENANCE

REPLACE GOVERNOR ASSEMBLY, GOVERNOR BODY ASSEMBLY,

AND GOVERNOR DRIVE GEAR

INITIAL SETUP:

Tools and Special Tools

Pliers Set, Retaining Ring (WP 0079, Item 27)

Socket, Socket Wrench, 3/8” Drive, 6-Point, Regular,

1/2” (WP 0079, Item 37)

Stand, Maintenance, Automotive (WP 0079, Item 40)

Tool Kit, General Mechanic’s (GMTK) (WP 0079,

Item 45)

Wrench, Torque, Ratcheting, 1/2” Drive, 250 lb-ft

(WP 0079, Item 51)

Materials/Parts

Gasket (WP 0080, Item 29)

Personnel Required

Track Vehicle Repairer, 91H10

Equipment Condition

Transmission removed from vehicle or container (TM

9-2350-277-13&P)

Oil f ll tube assembly removed (WP 0006)

Right cover assembly removed (WP 0016)

REMOVE GOVERNOR ASSEMBLY, GOVERNOR BODY ASSEMBLY, AND GOVERNOR DRIVE GEAR

NOTE

Transmission is on maintenance stand, right end up.

1. Remove four bolts (Figure 1, Item 6) and four washers (Figure 1, Item 5) that retain access cover (Figure 1,

Item 4) to center housing (Figure 1, Item 1).

2. Remove access cover (Figure 1, Item 4) and gasket (Figure 1, Item 3). Discard gasket (Figure 1, Item 3).

3. Turn governor assembly (Figure 1, Item 2) slightly to the left (counter clockwise) and pull it from center housing

(Figure 1, Item 1).