TM-9-2520-272-40
CROSS-DRIVE TRANSMISSION WITH CONTAINER MODEL X200-4A
TECHNICAL MANUAL; SUSTAINMENT MAINTENANCE MANUAL
FEBRUARY 2012
TM-9-2520-272-40 - Page 550 of 620
TM 9-2520-272-40
0069
13.Rotate adapter plate (Figure 10, Item 16) on maintenance stand to match hole pattern in plate with holes on
bottom of transmission (Figure 10, Item 15).
14.Align holes in bottom of transmission (Figure 10, Item 15) with holes in adapter plate (Figure 10, Item 16).
15.Install washers (Figure 10, Item 17) (part of container adapter kit) under heads of three 1/2-13 x 2 inch bolts
(Figure 10, Item 18) (part of container adapter kit). Install bolts (Figure 10, Item 18) through three holes in
adapter plate (Figure 10, Item 16). Screw bolts (Figure 10, Item 18) into holes in bottom of transmission
(Figure 10, Item 15).
16.Torque three bolts (Figure 10, Item 18) to 80 to 95 lb-ft (108 to 129 N·m).
17.Remove three 3/8-16 x 1-3/4 inch bolts (Figure 10, Item 13) and six 3/8 inch washers (Figure 10, Item 14)
holding multiple-leg sling (Figure 10, Item 12).
18.Remove multiple-leg sling (Figure 10, Item 12).
Back to Top
