TM-9-2815-205-24
6V53/6V53T ENGINES, DIESEL WITH CONTAINERS; MODEL 5063-5299, MODEL 5063-5392, MODEL 5063-5393 AND MODEL 5063-539L
TECHNICAL MANUAL; FIELD AND SUSTAINMENT MAINTENANCE
FEBRUARY 2013
TM-9-2815-205-24 - Page 775 of 856
8
6
7
9
3
8
7
10
11
MODELS
5063-5392
5063-5393
5063-539L
RIGHT
VIEW
MAINT_423
Figure 2.
Remove Throttle Delay Lever and Rocker Shaft Bracket.
10.
Loosen locknut (Figure 3, Item 17) and back out adjusting screw (Figure 3, Item 19) on control tube lever
(Figure 3, Item 18). Slide injector control lever on injector control tube (Figure 3, Item 20) away from injector
control rack (Figure 3, Item 22).
11.
Remove bolt (Figure 3, Item 14), convex washer (Figure 3, Item 15), clamp (Figure 3, Item 16), and injector
(Figure 3, Item 13) in cylinder head.
CAUTION
Injector clamp must not interfere with follower spring or exhaust valve springs when
installed. Damage could occur to engine valve or injector clamp.
12.
Install cylinder compression adapter (Figure 3, Item 21), clamp (Figure 3, Item 16), convex washer
(Figure 3, Item 15), and bolt (Figure 3, Item 14) in injector tube. Torque bolt to 20–25 lb-ft (27–34 N·m).
Connect cylinder compression tester (Figure 3, Item 12) to adapter.
12
13
14
15
16
17
18
19
20
21
22
MAINT_424
Figure 3.
Remove Injector and Install Cylinder Compression Tester.
TM 9-2815-205-24
0101
0101-3
Back to Top
