TM-9-2815-210-34-2-1

ENGINE ASSEMBLY, DIESEL (MULTIFUEL): NATURALLY ASPIRATED OR TURBOCHARGED, FUEL-INJECTED, WATER-COOLED, 6-CYLINDER

TECHNICAL MANUAL; TROUBLESHOOTING; DIRECT SUPPORT AND GENERAL SUPPORT LEVEL; VOLUME 2 OF 2; PART 1 OF 2

APRIL 1981

TM-9-2815-210-34-2-1 - Page 220 of 259

TM 9-2815-210-34-2-1

3-42. PISTON AND CONNECTING ROD ASSEMBLIES.

CAUTION

It is easy to damage the equipment if you do not

know what you are doing. Do not try to do this

task unless you are experienced at it, or you

have an experienced person with you.

FRAME 1

1.

2.

3.

Turn engine overhaul stand so that crankshaft damper and pulley (1) are

facing up.

Using engine barring tool, turn crankshaft damper and pulley (1) until

cylinder number one piston and connecting rod assembly (2) and cylinder

number six piston and connecting rod assembly (3) are at bottom of stroke.

NOTE

Cylinder sleeves (4, 5, and 6) and piston and con-

necting rod assemblies (2, 3, and 7) are called by

numbers one to six counting from front to rear of

engine (8).

Using cylinder ridge reamer, ream out ridge at top of number one cylinder

sleeve (4) and number six cylinder sleeve (5) .

GO TO FRAME 2

3-172