TM-9-2815-210-34-2-1

ENGINE ASSEMBLY, DIESEL (MULTIFUEL): NATURALLY ASPIRATED OR TURBOCHARGED, FUEL-INJECTED, WATER-COOLED, 6-CYLINDER

TECHNICAL MANUAL; TROUBLESHOOTING; DIRECT SUPPORT AND GENERAL SUPPORT LEVEL; VOLUME 2 OF 2; PART 1 OF 2

APRIL 1981

TM-9-2815-210-34-2-1 - Page 226 of 259

TM 9-2815-210-34-2-1

3-43. CRANKSHAFT DAMPER AND PULLEY ASSEMBLY.

FRAME 1

Soldier A 1 .

2.

GO TO FRAME

Put two bolts (1) in crankshaft flange (2) as shown.

Wedge a length of steel bar stock (3) between two bolts (1) so

that other end of bar rests on floor. This will keep crankshaft

from turning when crankshaft damper and pulley retaining bolt

is taken out.

Hold steel bar in this position while soldier B takes

out crankshaft damper and pulley retaining bolt.

2

3-178