TM 9-2815-210-34-2-1
FRAME 4
CAUTION
Soldier A
Soldier B
Soldier A
Soldiers
A and B
Be careful not to scratch inside surface of cylinder
sleeves (1) when taking out piston and connecting rod
assemblies (2 and 3).
Be careful not to scratch or dent connecting rod upper
bearing halves (4) when pushing out piston and con-
necting rod assemblies (2 and 3). Push only on bottom
of connecting rod (5), not on bearing halves.
NOT E
Cylinder sleeves (1) may come out with piston and
connecting rod assemblies (2 and 3). If cylinder
sleeve comes out, tag it so it can be put back in the
same place.
1.
Watch top of cylinder number one piston and connecting rod as-
sembly (2).
Tell soldier B when piston rings (6) are clear of
cylinder sleeve (1).
2.
Using wood or nylon dowel and hammer, gently tap bottom of
cylinder number one connecting rod (5). Drive piston and con-
necting rod assembly (2) out of engine until soldier A tells you
piston rings (6) are clear of cylinder sleeve (1).
3.
Pull piston and connecting rod assembly (2) out of engine.
4.
Do steps 1 through 3 again for cylinder number six piston and
connecting rod assembly (3).
GO TO FRAME 5
3–175