TM-9-2815-210-34-2-1

ENGINE ASSEMBLY, DIESEL (MULTIFUEL): NATURALLY ASPIRATED OR TURBOCHARGED, FUEL-INJECTED, WATER-COOLED, 6-CYLINDER

TECHNICAL MANUAL; TROUBLESHOOTING; DIRECT SUPPORT AND GENERAL SUPPORT LEVEL; VOLUME 2 OF 2; PART 1 OF 2

APRIL 1981

TM-9-2815-210-34-2-1 - Page 221 of 259

TM 9-2815-210-34-2-1

FRAME 2

1.

2.

3.

4.

5.

GO

NOT E

Cylinders and piston and connecting rod assemblies are

called by numbers one to six counting from front to

rear of engine.

Turn crankshaft damper and pulley (1) until two bolts (2) holding cylinder

number one connecting rod bearing cap (3) can be easily reached, as shown.

Take out two bolts (2) and take out cylinder number one connecting rod

bearing cap (3).

Take off cylinder number one connecting rod bearing half (4). Tag it with

number of piston and connecting rod assembly it was taken from, followed

by letter “C” for cap.

Take out two bolts (5) and take out cylinder number six connecting rod

bearing cap (6).

Do step 3 again for number six connecting rod bearing half (4).

TO FRAME 3

3-173