TM-9-2815-210-34-2-1

ENGINE ASSEMBLY, DIESEL (MULTIFUEL): NATURALLY ASPIRATED OR TURBOCHARGED, FUEL-INJECTED, WATER-COOLED, 6-CYLINDER

TECHNICAL MANUAL; TROUBLESHOOTING; DIRECT SUPPORT AND GENERAL SUPPORT LEVEL; VOLUME 2 OF 2; PART 1 OF 2

APRIL 1981
TM-9-2815-210-34-2-1

  TM-9-2815-210-34-2-1 - Page 92 of 259

TM 9-2815-210-34-2-1
FRAME
2
1.
2.
3.
4.
Hold hub (1) of rear pulley flange (2).
Loosen locknut (3) inside spring
retainer (4).
About three threads of locknut should still mate with
threads of pulley shaft (5).
Put compressor pulley puller (6) into middle of outer pulley flange (7) as
shown.
Turn puller (6) until pulley assembly (8) breaks loose from air compressor
shaft (5) .
Take off locknut (3).
Take off pulley assembly (8) with drive belt (9). Take off and tag drive
belt (9).
GO TO FRAME 3
3-44


Back to Top