TM-9-2815-210-34-2-1

ENGINE ASSEMBLY, DIESEL (MULTIFUEL): NATURALLY ASPIRATED OR TURBOCHARGED, FUEL-INJECTED, WATER-COOLED, 6-CYLINDER

TECHNICAL MANUAL; TROUBLESHOOTING; DIRECT SUPPORT AND GENERAL SUPPORT LEVEL; VOLUME 2 OF 2; PART 1 OF 2

APRIL 1981
TM-9-2815-210-34-2-1

  TM-9-2815-210-34-2-1 - Page 87 of 259

TM 9-2815-210-34-2-1
FRAME 4
1.
2.
3.
4.
5.
NOTE
Fuel injection pump (1) shown is for engines LD-465-1,
LD-465-1C, and LDT-465-1C. This task is the same
for other engines.
Have machine shop make holding wrench (2). See
figure 3-1.
Join holding wrench (2) to fuel injection pump drive gear hub (3) using two
screws (4) as shown.
Take off nut (5).
Take out two screws (4) and take off holding wrench (2).
Pull off drive gear hub (3).
Put nut (5) back on fuel pump driveshaft (6).
END OF TASK
3-39


Back to Top