TM-9-2815-210-34-2-2

ENGINE ASSEMBLY, DIESEL (MULTIFUEL): NATURALLY ASPIRATED OR TURBOCHARGED, FUEL-INJECTED, WATER-COOLED, 6-CYLINDER

TECHNICAL MANUAL; TROUBLESHOOTING; DIRECT SUPPORT AND GENERAL SUPPORT LEVEL; VOLUME 2 OF 2; PART 2 OF 2

APRIL 1981

TM-9-2815-210-34-2-2 - Page 176 of 968

TM 9-2815-210-34-2-2

(b) Engines LDS-465-1, LDS-465-1A, and LDS-465-2

FRAME 1

1.

2.

3.

4.

CAUTION

Be careful not to damage screens (1) during cleaning

with brass wire probe.

Clean four oil pump tubes (2) with a brass wire probe. Use a wire brush to

take out carbon and sludge.

WARNING

Dry cleaning solvent is flammable. Do not use near an

open flame. Keep a fire extinguisher nearby when solvent

is used. Use only in well-ventilated places. Failure to

do this may result in injury to personnel and damage to

equipment.

Wash four oil pump tubes (2) by flushing with dry cleaning solvent.

WARNING

Eye shields must be worn when using compressed air.

Eye injury can occur if eye shields are not used.

Dry four oil pump tubes (2) by blowing them out with compressed sir.

Clean brace (3), flange (4), and four clamps (5) using dry cleaning solvent.

Use a stiff brush to take off sludge and gum deposits.

END OF TASK

4-157