TM-9-2815-210-34-2-2

ENGINE ASSEMBLY, DIESEL (MULTIFUEL): NATURALLY ASPIRATED OR TURBOCHARGED, FUEL-INJECTED, WATER-COOLED, 6-CYLINDER

TECHNICAL MANUAL; TROUBLESHOOTING; DIRECT SUPPORT AND GENERAL SUPPORT LEVEL; VOLUME 2 OF 2; PART 2 OF 2

APRIL 1981

TM-9-2815-210-34-2-2 - Page 175 of 968

TM 9-2815-210-34-2-2

(1) Oil pump tubes.

(a) Engines LD-465-1, LD-465-lC, and LDT-465-lC.

FRAME 1

CAUTION

Be careful not to damage screens (1) diring cleaning

with brass wire probe.

1. Clean three oil pump tubes (2)

take off carbon and sludge.

Dry cleaning solvent is

with a brass wire probe. Use a wire brush to

WARNING

flammable.

Do not use near

an open flame.

Keep a fire extinguisher nearby when

solvent is used. Use only in well-ventilated places.

Failure to do this may result in injury to personnel

and damage to equipment.

2. Wash three oil pump tubes (2) by flushing with dry cleaning solvent.

WARNING

Eye shields must be worn when using compressed air.

Eye injury can occur if eye shields are not used.

3. Dry three oil pump tubes (2) by blowing them out with compressed air.

4. Clean bracket (3) and flange (4) with dry cleaning solvent. Use a stiff brush

to take off sludge and gum deposits.

END OF TASK

4-156

b.

Cleaning.