TM-9-2815-210-34-2-2

ENGINE ASSEMBLY, DIESEL (MULTIFUEL): NATURALLY ASPIRATED OR TURBOCHARGED, FUEL-INJECTED, WATER-COOLED, 6-CYLINDER

TECHNICAL MANUAL; TROUBLESHOOTING; DIRECT SUPPORT AND GENERAL SUPPORT LEVEL; VOLUME 2 OF 2; PART 2 OF 2

APRIL 1981

  TM-9-2815-210-34-2-2 - Page 430 of 968

TM 9-2815-210-34-2-2
e. Assembly.
(1) Adjusting screw type nozzle and holder assembly.
NOTE
Work area must be kept clean.
FRAME 1
CAUTION
Do not touch valve (1) with hands.
Oil may rub off
causing a sticking valve which can damage equipment.
Do not let polished surface of valve or nozzle body (2)
touch any hard surfaces.
Nicks or scratches can dam-
age equipment.
1.
Hold valve (1) with pliers, as shown, and push into valve body (2).
2.
Put valve (1) with valve body (2) into nozzle holder (3). Put nozzle holder
into soft-jawed vise, as shown.
3.
Put on and tights nozzle capnut (4) to 40 to 45 pound-feet.
GO TO FRAME 2
4-411


Back to Top