TM-9-2815-210-34-2-2

ENGINE ASSEMBLY, DIESEL (MULTIFUEL): NATURALLY ASPIRATED OR TURBOCHARGED, FUEL-INJECTED, WATER-COOLED, 6-CYLINDER

TECHNICAL MANUAL; TROUBLESHOOTING; DIRECT SUPPORT AND GENERAL SUPPORT LEVEL; VOLUME 2 OF 2; PART 2 OF 2

APRIL 1981

  TM-9-2815-210-34-2-2 - Page 435 of 968

TM 9-2815-210-34-2-2
b.
Cleaning.
FRAME 1
NOTE
Purpose of agitators to stir cleaning compound while
it is boiling. These steps for fabrication of agitator
are general and may be altered if necessary.
1.
Cut about two feet of copper tube (1) and seal one end (2) by flattening with
hammer.
2.
Coil tube (1) as shown and drill small holes (3) about 1/2 inch apart along
underside of coiled end.
3.
Put fitting (4) on other end of tube (1).
GO TO FRAME 2
4-416


Back to Top