TM-9-2815-210-34-2-2

ENGINE ASSEMBLY, DIESEL (MULTIFUEL): NATURALLY ASPIRATED OR TURBOCHARGED, FUEL-INJECTED, WATER-COOLED, 6-CYLINDER

TECHNICAL MANUAL; TROUBLESHOOTING; DIRECT SUPPORT AND GENERAL SUPPORT LEVEL; VOLUME 2 OF 2; PART 2 OF 2

APRIL 1981

TM-9-2815-210-34-2-2 - Page 444 of 968

TM 9-2815-210-34-2-2

b. There are no special cleaning procedures needed. Refer t o

cleaning procedures given in para 4-3.

c .

Inspection and Repair.

FRAME 1

1.

2.

3.

4.

Check that three expansion plugs (1) are not loose, leaking or damaged in any

other way.

If any expansion plug is damaged, get a new one.

Check that four studs (2) are not loose, stripped, crossthreaded or damaged

in any other way.

Fix minor thread damage with a thread chaser. If more

repair is needed, get a new part.

NOTE

To check for cracks, refer to para 4-4.

Check that intake manifold (3) is not cracked, bent or damaged in any other

way.

If repair is needed, get a new part.

WARNING

Dry cleaning solvent is flammable. Do not use near an

open flame.

Keep a fire extinguisher nearby when sol-

vent is used.

Use only in well-ventilated places.

Failure to do this may result in injury to personnel and

damage to equipment.

Check that gasket surfaces (4) have no nicks, burrs or scratches. Take out

minor nicks, burrs or scratches with a fine mill file or crocus cloth dipped

in dry cleaning solvent.

If more repair is needed, get a new intake manifold

(3) .

GO TO FRAME 2

4-425