TM-9-2815-210-34-2-2
ENGINE ASSEMBLY, DIESEL (MULTIFUEL): NATURALLY ASPIRATED OR TURBOCHARGED, FUEL-INJECTED, WATER-COOLED, 6-CYLINDER
TECHNICAL MANUAL; TROUBLESHOOTING; DIRECT SUPPORT AND GENERAL SUPPORT LEVEL; VOLUME 2 OF 2; PART 2 OF 2
APRIL 1981
TM-9-2815-210-34-2-2 - Page 448 of 968
TM 9-2815-210-34-2-2
4-45. EXHAUST MANIFOLD ASSEMBLY.
a.
Disassembly.
FRAME 1
WARNING
1.
2.
3.
4.
5.
6.
Wear welder’s gloves when handling hot parts. Failure
to do so will result in serious burns.
CAUTION
Do not use cutting tip on welding torch or exhaust
manifold assembly may be damaged.
Put center exhaust manifold section (1) in vise.
Using welding torch, heat front exhaust manifold section (2) near joint (3).
Pull front exhaust manifold section (2) from center exhaust manifold section (1)
Take three seal rings (4) out
Throw away seal rings.
Do steps 2, 3, and 4 for rear
Take center exhaust manifold
of groove in front exhaust manifold section (2).
exhaust manifold section
section (1) out of vise.
(5) .
END OF TASK
4-429
Back to Top
