TM-9-2815-210-34-2-2

ENGINE ASSEMBLY, DIESEL (MULTIFUEL): NATURALLY ASPIRATED OR TURBOCHARGED, FUEL-INJECTED, WATER-COOLED, 6-CYLINDER

TECHNICAL MANUAL; TROUBLESHOOTING; DIRECT SUPPORT AND GENERAL SUPPORT LEVEL; VOLUME 2 OF 2; PART 2 OF 2

APRIL 1981

  TM-9-2815-210-34-2-2 - Page 490 of 968

TM 9-2815-210-34-2-2
(4) Replacement.
FRAME 1
1.
2.
3.
4.
NOTE
Air compressor shown is for engine LDS-465-2.
Procedure is same for all other engines.
Screw unloader valve elbow (1) into unloader valve (2). Tighten elbow so hole
in elbow will point up and in towards engine side of compressor as shown.
Put unloader valve gasket (3) on air compressor (4).
Place unloader valve (2) on air compressor (4) so studs on air compressor
fit through holes in valve.
Screw on and tighten two nuts and lockwashers (5).
END OF TASK
4-471


Back to Top