TM-9-2815-210-34-2-2

ENGINE ASSEMBLY, DIESEL (MULTIFUEL): NATURALLY ASPIRATED OR TURBOCHARGED, FUEL-INJECTED, WATER-COOLED, 6-CYLINDER

TECHNICAL MANUAL; TROUBLESHOOTING; DIRECT SUPPORT AND GENERAL SUPPORT LEVEL; VOLUME 2 OF 2; PART 2 OF 2

APRIL 1981

TM-9-2815-210-34-2-2 - Page 622 of 968

TM 9-2815-210-34-2-2

b .

Inspection and Repair.

NOTE

This task is shown for one tube and one tube nut.

It can be used for all flame heater tubes and tube

nuts .

FRAME 1

1.

2.

3.

4.

5.

6.

Check that plastic tubing (1) is not cracked, kinked or brittle.

Check that plastic tubing (1) has not cracked around tube nuts (2).

Throw away plastic tubing (1) if it is cracked or damaged and get a new one.

Throw away plastic tubing (1) if tube nuts (2) are stripped or damaged and

get a new one.

Check that 1/4-inch plastic tubing (1) has not shrunk at tube nut ferrules

(2). Throw away 1/4-inch plastic tubing if No. 28 drill shank (3) cannot be

put in tube opening.

Check that 1/8-inch plastic tubing (1) has not shrunk at tube nut ferrule (2).

Throw away 1/8-inch plastic tubing if 1/32-inch drill shank (3) cannot be put

in tubing opening.

END OF TASK

4-603