TM-9-2815-210-34-2-2

ENGINE ASSEMBLY, DIESEL (MULTIFUEL): NATURALLY ASPIRATED OR TURBOCHARGED, FUEL-INJECTED, WATER-COOLED, 6-CYLINDER

TECHNICAL MANUAL; TROUBLESHOOTING; DIRECT SUPPORT AND GENERAL SUPPORT LEVEL; VOLUME 2 OF 2; PART 2 OF 2

APRIL 1981

TM-9-2815-210-34-2-2 - Page 629 of 968

TM 9-2815-210-34-2-2

FRAME 2

1.

Check to see that six screws (1), three nuts (2), and nine lockwashers (3)

are not stripped.

If screws, nuts or lockwashers are damaged, throw them

away and get new ones.

2.

Put a light coat of engine lubricating oil on crankshaft front oil seal (4).

3.

Using arbor press and pressing plate, press crankshaft front oil seal (4) in

from front of timing gear cover (5).

Lip of crankshaft front oil seal must

face out.

Stop pressing when crankshaft front oil seal is flush with top edge

of crankshaft front oil seal bore (6).

END OF TASK

4-610