TM-9-2815-210-34-2-2

ENGINE ASSEMBLY, DIESEL (MULTIFUEL): NATURALLY ASPIRATED OR TURBOCHARGED, FUEL-INJECTED, WATER-COOLED, 6-CYLINDER

TECHNICAL MANUAL; TROUBLESHOOTING; DIRECT SUPPORT AND GENERAL SUPPORT LEVEL; VOLUME 2 OF 2; PART 2 OF 2

APRIL 1981

TM-9-2815-210-34-2-2 - Page 630 of 968

TM 9-2815-210-34-2-2

CHAPTER 5

FINAL ASSEMBLY

Section I. SCOPE

5-1. EQUIPMENT ITEMS

engine components into a

5-2. EQUIPMENT ITEMS

chapter.

COVERED.

This

final assembly.

NOT COVERED.

chapter gives

All equipment

Section II.

ASSEMBLY OF

NOTE

This procedure is the same

except where noted.

TOOLS:

Ring compressor, pn C-10899159

instructions to assemble the

items are covered in this

ENGINE ASSEMBLY

for all engine models

-Din-per pulley locator (fabricated locally)

Oil pressure regulator valve adapter (fabricated locally)

Pilot

bolt

(fabricated

locally)

Cylinder head nut wrench, pn D-10951485

Engine transport stand, NSN 4910-00-338-6673

Engine maintenance stand, NSN 4910-00-795-0189

SUPPLIES:

Anti-scuff lubricant, Lubrizol 1060 or Texaco TLA111

Sealing compound, type II, MIL-S-45180

Lubricating oil, ICE, OE/HDO 30, MIL-L-2104

Cylinder head gasket (2)

Sealant, MIL-S-7916

Crankshaft rear oil seal

Crankshaft rear oil seal housing gasket

Lubricating oil, ICE, OE/HDO 10, MIL-L-2104

Flywheel housing-to-crankcase gasket

Intake and exhaust manifold-to-cylinder head gasket (2)

Thermostat housing-to-cylinder head gasket

Oil pressure regulator valve housing-to-crankcase gasket

Injector

pump

adapter-to-crankcase

gasket

Oil cooler gasket and preformed packing set

Cylinder head breather tube adapter-to-cylinder head

covers gaskets (2)

Hydraulic pump-to-crankcase gasket

Oil drain gasket

Oil inlet adapter gasket

Turbocharger-to-exhaust manifold gasket

Intake elbow flame heater spark plug gasket

Starter mounting gasket (engine LDS 465-2)

Starter mounting gasket set

PERSONNEL: Two

EQUIPMENT CONDITION:

All engine components cleaned and ready for assembly

5-1